Xbox 360 connectivity kit for 360 drives+liteon probe

Xbox 360 connectivity kit for 360 drives+liteon probe

http://i45.tinypic.com/2mepmb9.jpg

Features
Sturdy enclosure to protect and keep all connections from breaking unlike others.
A male molex to hook directly up to Pc's power supply.
Led for on/off switch
Momentary Push button for open/close
dvd connector for connecting to 360 dvd drive
On/off switch combined with push button makes vend. mode a simple process.
you dont have to worry about this product blowing fuses or sending your 360 drive up in smoke like the ck3's and other kits that require fuses...
Plus lite-on usb probe with led for liteon 7 series...Have also left the tx line out through a small hole in pen case so you can always easily test in hyper terminal to make sure if functioning correctly...

To use this product you will need to open your case which will void your warranty...

works flawlessly :011:

Is this a homemade kit?? I've never had a problem with the CK3 switch or probe. But your behind the times already, Team xcuter have developed a dual pronged probe to use with all the liteon drives not just the 7xxxx. So theres no need for the litetouch switch, only a few trace cuts and resoldering after the read/write

use with all the liteon drives to it has litetouch switch if needed and what resoldering lol no soldering with that lad use jungle flasher use ite-on usb probe thats it bro flashed all done

Please try to explain again in a little more detail and this time use some grammar. I didn't quite understand the post.

Lol, that is like looking at a find the word puzzle.

what did'nt you understand bro sorry if you dont understand if you look here this is what it does bro Xbox 360 Lite On DVD Key Dumping >> Xbox 360 Lite On DVD Key Dumping - TIAO's USB Key Extractor - TIAO's Wiki

Like I said, This is outdated! That guide is for the original Liton DG16D2S. With the later liteon drives you needed the LT switch to be soldered on to the board in the drive. Now there is a dual probe which has two pronges instead so that instead of making lots of trace cuts and soldering the switch on,now only make three cuts and use this new tool and repair the cuts with trace glue or solder. Easy peasy.

lol i'll worry about jump when i get to it have not done later liteon drives as of yet but point taking crazycastle :cool:

Also look at the newest JF released today, its awsome but will take some time to get used too. Once the traces have been repaired keep the inquiry.bin and key in the folder and when updating it can check the inquiry against the drive and the key against the inquiry and then write to the drive so no need to cut/solder again......I think thats what it said. Gonna need some more reading before giving it a shot.

Now that will be wort a read i thought it was still in the making but found it looking for something else >> Ixtreme Lite 1.7 just released!! JF v1.70.. and is as you said no need to cut/solder again :cool: which is very nice indeed for us hehe..