Results 1 to 3 of 3

Thread: Chip works once, then nothing

  1. #1
    Junior Member
    Join Date
    Dec 2008
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Chip works once, then nothing

    OK, so if my Wii is uplugged for 10 or minutes, I load a backup game and it loads and works fine. Without powering down, if I eject the disc and load another backup game, I get the error. If I power down, restart, and load a backup game, I still get the error. If I unplug power for 10 to 15 minutes and load up a backup, it plays fine again. I upgraded the chip to firmware 1.2.

    Any Ideas?

  2. #2
    Junior Member bigtone0777's Avatar
    Join Date
    Oct 2008
    Posts
    37
    Thanks
    10
    Thanked 2 Times in 2 Posts
    If you have fitted your chip with a WiiClip make sure there are no bent legs on the clip. If there is gently tease out to the centre a little with a TINY screw driver or similar to ensure a good contact between the legs on the clip and the legs on the main chip.

    Hope this helps

    Tony

  3. #3
    Junior Member
    Join Date
    Nov 2008
    Location
    Roosendaal, Netherlands
    Posts
    32
    Thanks
    2
    Thanked 6 Times in 5 Posts
    firmware 1.2 sounds like wiikey2.

    check if ur chip (/ clip) is genuine.

    like bigtone stated in case of wiiclip usage:
    check for bent pins and try refitting the clip.
    check if the right points are soldered.

    in case of direct soldering to the board:
    check for long wires.
    check for bad soldering.

    make sure you write your images using imgburn at 4x speed with verbatim/memorex-r to make sure that's not the problem.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •