PLZ! HElp... I have been looking for the input and eject problem two weeks long...
Hi I am so sad that i can't use the wiikey2. Right now, i am having a exam and i can't concentrate, plz if anyone, i beg for your help.....
My wii is D2E
this is my problem, I bought the wiikey2 and wiichip v14 (solderless) from Canadamod, but the wii would not accept any of my Dvd, when i remove the chip, it work completely fine with no eject issue at all.Also the wiikey remain red light all the time. (i am sure , i setted up properly like this picture http://techsick.com/images/solderless-no-gap.jpg, *this is not my wii) So i looked in google to search for the solution, i found that it should be flashing 3 or 4 time with red and blue and then off, and then i tried to reset the wiikey 2 (the black part lift up a little)and i get the blue light remain(not flashing). And i could put the dvd with no eject issue. I don't think it normal that the blue light remain, so i wondering if any one have a similar problem like me could help me.
Just one more thing, i searched in this forum and i found a solution for this
But i not sure, cause it is too dangerous, it said i have to cut the G point,
but what if it doesn't work, then i going to waste all my hope for doing this, because i can't buy any more wiikey2 for some reason. Plz , if anyone could help will be appreciated.
Btw, i don't have a good quality camera, sorry
(Sorry if my english is confusing, english is not my first language)
Last edited by bbman233615; 03-02-2009 at 06:54 PM.
I used THIS to fix my problem.
that THIS is a powerful tool, no one notes !
advice to bbman:
the trace (ie. unused etch path on the flex circuit) may hv caused impedence issue to the wiikey functions. cut it as is, or even cut closer to the clip. no harm!
u're likely hving improper seating problem with clips.
Last edited by billyhome; 03-02-2009 at 11:24 PM.
i already searched, but their problem is different than me, because my wiikey2 is pre-soldered, and those people were soldered with wire and using the alternate g point, but i don't even know how to do separate wiikey2 from the wiichip v14,i have no clue at all about the soldering and the hot tool, that why i buying wii chip....
Originally Posted by ChrisChown
ty for replying, but i not sure what you saying"unused etch path on the flex circuit", actually i don't think i have an eject issue, because i don't even able to put any dvd to wii, i think my problem is the wii won't accpet any dsc, and the wiikey2 remain red light, when i remove it, the input work fine...
Originally Posted by billyhome
Last edited by bbman233615; 03-03-2009 at 03:42 PM.
You may need to reseat your clip. If that doesn't work, you will need to cut any unused traces.
The "unused etch path on the flex circuit" is the path connects to no where to the electronic module of wiikey2. Simply, it's mark with the short line as shown on ur attached photo.
as excessive capacitance may cause unpredictable electronic errors, plz listen to the MODDERS's comment. cut with a sharp blade, it's easy.