Results 1 to 4 of 4

Thread: getting frustrated

  1. #1
    Junior Member
    Join Date
    Feb 2009
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    getting frustrated

    Ok I bought a wiikey2 and clip combo from candamods.
    I told them that I had a gc2-d2c chip.
    I installed the clip like I was suppose to, and the dvd drive is dead. I take the clip off and the drive works fine. Then I noticed a piece of tape between the solder points D thru G. should those all have been soldered also? my serial number sticker is yellow, so should I solder just the G, or should d thru g all be soldered. Thanks for the help. I sent Canadamods an email a couple of days ago with no response.

    thanks again
    Indiana Jim

  2. #2
    Member
    Join Date
    Dec 2008
    Posts
    253
    Thanks
    0
    Thanked 33 Times in 31 Posts
    Post a picture and you will get more accurate responses.

  3. #3
    Junior Member
    Join Date
    Feb 2009
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I think I just found the answer. I believe since I have a yellow serial # wii2 key and my chip is a D2c Then A,B,C, and G should be soldered. Can anyone confirm this.

  4. #4
    Member
    Join Date
    Dec 2008
    Posts
    253
    Thanks
    0
    Thanked 33 Times in 31 Posts
    Yes you are correct. Not sure if it fixes your problem but only a,b,c and g are needed for yellow sticker. (power and ground too obviously)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •