Configurable USB Loader problem
I followed the guide by mauifrog and it worked perfectly and was actually quite fun.
However I'm stuck at the Configurable USB loader (v60 249). When I select "USB Mass Storage Device", it keeps telling me "Partition FAT1 not found".
I formatted my toshiba 1tb disk exactly as instructed using EASEUS Partition master.
I feel so close....
your 249 is rev17(doesnt work with fat32 loading) you have to use 250 or 247,248
in the cfg config.txt make sure you have a line ios = 250
or just get the 222.dol(rename to boot.dol)
Last edited by Cile; 12-13-2010 at 07:58 PM.
still no go
I DLed the file and renamed and replaced it. Still no go.
It looks different.
Maybe its this hd? Its not on the recommended list, but its not listed as "not working" either.
when i start usb loader gives me 30 second count and resets the wii what going on any one wii4.2u
Retired WiiHacks Staff
make sure its in the correct port or make sure it is pluged in properly.
Originally Posted by empo30
thanks to bmarlo for this signature