Page 1 of 3 123 LastLast
Results 1 to 10 of 25

Thread: stuck in priiloader..remote is not sync..please HELP

  1. #1
    Junior Member
    Join Date
    Dec 2009
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    stuck in priiloader..remote is not sync..please HELP

    Hi...
    I just semi-brick my wii. I haven't GC pad or controller, and my son is verry unhappy...The console is in priiloader boot and remote is unsync..just used at another console.....

    How can I bypass priiloader boot without remote? Now firm is 4.1E and console was softmoded ok, until resync remote at anothe r console..

    Please help me....

  2. #2
    Junior Member
    Join Date
    Nov 2009
    Posts
    3
    Thanks
    2
    Thanked 0 Times in 0 Posts

    same problem

    I have the same problem. I followed the new 4.2 guide and everything was working great. Loaded contra rebirth from triforce and now my remote will never sync. going to do some more searching in the forumns but have not found a solution yet. Hope I didnt kill my wii : (.

  3. #3
    Senior Member
    WiiHacks Staff
    Senior Moderator
    Only site donators may send a PM to WiiHacks Staff
    oddgriffin's Avatar
    Join Date
    Nov 2009
    Location
    New Franklin, Ohio. USA
    Posts
    10,172
    Thanks
    2,195
    Thanked 2,558 Times in 2,004 Posts
    Blog Entries
    2
    Are you sure you are syncing it correctly? All you have to do is hold the wiimote in front of the sensor bar. Press the red button on the wii once, then press the red button on the wiimote once. It should begin blinking and stop pretty quickly.

  4. #4
    Junior Member
    Join Date
    Dec 2009
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    nope...the remote won't sync...

    was my foult...i don't activate autoboot....and after that...i resync my remote on another console......

    Please any help....

    TNX

  5. #5
    Junior Member
    Join Date
    Nov 2009
    Posts
    3
    Thanks
    2
    Thanked 0 Times in 0 Posts
    i tried re-syncing my remote a hundred times. all the green lights on my remote just keep flashing. when i power on my wii it goes to the health and warning screen, then to the system menu. holding reset goes to preloader but I cant get my remote to sync. used the 4.2 menu guide and triforce guide, it was working great for about a day. tried replacing my batteries which did not help.

    thanks for any ideas

  6. #6
    Junior Member
    Join Date
    Dec 2009
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts
    maybe..gamecube controller is single solution...tommorow i will buy one..and test.....

    If is another solution...please help....

    P.S. SD card not boot....with any programs on it (boot.doll, install.doll, boot .elf, etc)

  7. #7
    Senior Member
    WiiHacks Staff
    Senior Moderator
    Only site donators may send a PM to WiiHacks Staff
    oddgriffin's Avatar
    Join Date
    Nov 2009
    Location
    New Franklin, Ohio. USA
    Posts
    10,172
    Thanks
    2,195
    Thanked 2,558 Times in 2,004 Posts
    Blog Entries
    2
    I don't know where you are, but here in ohio we have Dollar General and Family dollar. They sell those gamecube compatible controllers for 10 bucks and they work just fine.

  8. #8
    Junior Member
    Join Date
    Dec 2009
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts
    yes ..i'm from romania and i will pay 25 dollars for one hama clone wii gc controller.. but the money is not a problem..is for my son...

    VEEEERY thanks...

  9. #9
    Junior Member
    Join Date
    Nov 2009
    Posts
    3
    Thanks
    2
    Thanked 0 Times in 0 Posts

    fixed!

    found the solution on nintendo's website. who would have thought. this is what I did to get my remote's synced:

    (1) unplug your wii for five seconds
    (2) power on the wii and wait for it to get to the health and safty warning or preloader screen
    (3) press and hold the red button on the wii thats above the sd card slot for at least 15 seconds
    (4) remove the battery cover on the wii remote and press the hidden red button
    (5) quickly press and release the red button above the sd card on the wii again
    (6) When the Player LED blinking stops and stays lit, the syncing is complete

    took me a few tries, but it finally worked. I thought I bricked my wii so I am happy. back to excite bike world tour

  10. #10
    Junior Member
    Join Date
    Dec 2009
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts
    yes man....your console is in warning screen, not in priiloader screen....for me, single option is gc controller...

    tnx

Page 1 of 3 123 LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •