I put a flatmii into my wii last night and all went fine other than 1 little problem.
1 of the wires broke off on the little 2 pin connector that goes from the front panel to the board. I soldered the cable back on to the pin and reassembled the wii. Everything is working fine except that I now have no red/yellow standby light. The green power light is working fine when the wii is turned on.

Before I go and take it apart again and redo the connection, does anyone know exactly what that 2 wire connection feeds?
Does it just feed the standby or does it feed the green power light too?

Basically I just want to figure out do I have a bad connection, or a dead LED.

Thanks.