well, i dont know if here is the right place to post this:
i recentley bricked my wii, here is the scenario:
1- korean wii - english menu - was on 3.2u and hbc 0.9
2- installed hbc 1.0.6
3- installed IOS60 (Patched)
4- installed Preloader 0.29 (couldn't run HBC)
5- installed another Preloader 0.29 (could load HBC)
6- dowloaded sysetm menu 4.0u (V417) with NUSD V1.2 having key.bin and kk.bin in the same directory
7- ran the output wad file from wad manager 1.4 and restart.
8- resulted in a garbled screen with white and green stripes whenever i turn on! (preloader not working either)
i can go to recovery mode by my GC controller and it shows 4.0(KOR).
a) what did i do wrong?
b) can i fix it?
Tnx for the quick reply.
unfortunately i could only install bootmii as IOS, so i didnt install at all!
i had only installed cios38 rev14.
i also dont have a modchip, but if thats the only way, i can get a drivekey or anything else.
You could buy a mod chip and use savemiifrii
what firmware should i install after that (i presume should be installed through an autoboot disk)?
i believe it shoud be newer than what is currently on my wii (4.0(KOR)), but can you be more specific?
I am not sure what you should install. How did you end up on 4.0(kor) when you installed 4.0u. You will need to wait for someone with more experience to help you.
alright man as soon as i get this new wii, i will ask you for everything i should do before modding it so i can be as safe as possible/
mauifrog help!!! My wii is about to brick again. The HomeBrew Channel is upside down!!! Except this time i made a Backup of my Nand!