Page 1 of 2 12 LastLast
Results 1 to 10 of 15

Thread: USB Loader GX Game Issues!

  1. #1
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Question USB Loader GX Game Issues!

    My Problem:
    I have just recently got USB Loader GX to work. But when i go on my games for example: COD: MW3, i play nicely for a while on campaign and suddenly the whole wii freezes which i mean by the graphics freeze and i mean the WHOLE wii because none of the the remote buttons work, it also makes a annoying BEEEEEEEEEEEEEP noise and just stays like that. I have to hold the power button for a while to turn it off and have to start again.

    My thoughts:
    i don't think it is a problem with the cios's because it doesn't get stuck at the loading sreen, I can get the game running fine. But the problem only occurs during gameplay.

    My Wii:
    System Menu 4.3 Pal
    I have USB Loader GX as my usb loader.
    I use the FAT32 usb format and use Wii Backup Manager to transfer my games.
    I use a micro sd card that i put in a micro sd to usb adapter.(because the sd card slot, i need for my other sd card, to launch the loader.) >>>>>>>>>>>>>>>>>>>>

    I will post my system check later. it would be nice if some one could provide a step by step tutorial but any help would be appreciated!
    Last edited by Wen Da Liu; 03-28-2012 at 02:06 PM.

  2. #2
    New Member Grandpa1959's Avatar
    Join Date
    Aug 2009
    Location
    Birmingham,England
    Posts
    540
    Thanks
    191
    Thanked 119 Times in 104 Posts
    Hi Dude! I have never had much luck with Flash drives (USB Adapters) It seems there is a lot of high speed info on the move and a solid state chip can't handle it. Especially COD games A small USB HDD is quite cheap. Have a look for the MW3 guide on here.

  3. #3
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Quote Originally Posted by Grandpa1959 View Post
    Hi Dude! I have never had much luck with Flash drives (USB Adapters) It seems there is a lot of high speed info on the move and a solid state chip can't handle it. Especially COD games A small USB HDD is quite cheap. Have a look for the MW3 guide on here.
    So should i put the micro sd card(that have my wbfs games in) through a sd card adapter instead and then place it in the sd slot at the front of the wii?
    And also if i do have to do that, would the usb loader forwarder still work if i put the usb loader gx loader in the sd card(with my wbfs games) and load it from the system menu? because i have two sd cards one for my homebrew channel apps and the other with my wbfs games. (if you don't undertand what i mean, basically, if i move my usb loader gx from the sd card (that i use for my homebrew channel) into the sd card with my wbfs games, will the usb loader gx still boot from the forwarder on my wii menu?


    Sorry for the big pictures but i try explaining using pictures.

  4. #4
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Here is my system Check:

    Last edited by Wen Da Liu; 03-31-2012 at 09:27 AM. Reason: spoiler

  5. #5
    WiiHacks Staff
    Only Site Donators Can PM Staff
    Forum Administrator
    IRC AOP
    skellinator's Avatar
    Join Date
    Aug 2010
    Location
    SE United States
    Posts
    6,067
    Thanks
    832
    Thanked 2,083 Times in 1,757 Posts
    I guess you have usbloader set to run on 250? You could use a bit of an upgrade on that mod, you only have one cios for games there, and that is the one for cod. Most other games wont run on a 58 base cios. Look into the softmod any wii guide and seriously consider following it. There is a "what this guide installs" tab that will shouw you what I am talking about.

    I dont think gx will read games from the sd slot, and if it would you would still need the app on there to launch the loader. The problem most likely is the card/adaptor set up. Refer to Grandpa's post and consider spending a few bucks if you want to fix your problem.

  6. 1 User Says Thank You skellinator For This Useful Post

    Jax

  7. #6
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I have been trying to install different cioses but suddenly when i went on my usb loader channel it startsup and says loading ios 249 and 250 but then it says: waiting for hdd: (20/19/18...) sec left and after 20 secconds it shows up usb device not found!

  8. #7
    WiiHacks Staff
    Only Site Donators Can PM Staff
    Forum Administrator
    IRC AOP
    skellinator's Avatar
    Join Date
    Aug 2010
    Location
    SE United States
    Posts
    6,067
    Thanks
    832
    Thanked 2,083 Times in 1,757 Posts
    That means that either you have the usb plugged into the wrong port, or your usb device is not compatible.
    What different cios did you try to install? Did you look at the ANY WII guide like I suggested? Maybe another syscheck is called for, but the guide will set you up with everything you need except for a compatible usb device.

  9. #8
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Here is my system check after the error:

    Last edited by Wen Da Liu; 03-31-2012 at 09:32 AM. Reason: spoiler

  10. #9
    Jax
    Jax is offline
    Senior Member
    Retired WiiHacks Staff
    Jax's Avatar
    Join Date
    Apr 2009
    Location
    Schenectady,NY
    Posts
    3,622
    Thanks
    3,205
    Thanked 1,322 Times in 1,105 Posts
    Take Skellinator's Advice and look over The Soft Mod Any Wii Guide.

    Start from,Soft Mod With Homebrew Channel Installed.
    Read everything a couple of times , then proceed to follow it through.

    This will set you straight.
    Last edited by Jax; 03-31-2012 at 10:47 AM. Reason: Fixed Spacing..

  11. 1 User Says Thank You Jax For This Useful Post


  12. #10
    New Member
    Join Date
    Mar 2012
    Posts
    10
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Do i have to follow it all the way from the homebrew channel?

Page 1 of 2 12 LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •