New to wii, Need help
I'm new to the wii hacking and homebrew scene, infact I am new to the wii scene i just bought my wii a few hours ago. I have been doing alot of research on which modchip I need but when it comes down to it I would rather have your opinions because after all I am new to this. I am sure you get alot of questions about which modchip to use sorry if i add one more to them.
My serial is Lu586137985
the wii serial tracker says the following
There is a 50% chance that your drive chip is a GC2-D2C
There is a 50% chance that the pins on your drive chip are not cut.
Any help will be greatly appreciated thanks.
Last edited by Master_Shake; 08-31-2008 at 07:28 PM.
you can use the d2pro9, wasabi, or wiizard. you have a d2e wii. if you are going to go solderless i would go with wasabi on clip as its got no issues. d2pro v3 on solderless for d2e has a few bugs on certain drives.
Hello Master Shake and welcome aboard..
i have sent you a PM with more details on your choices..
Thank you guys very much for the info so if I went solderless is this what I would need?
Mod*Central*Ltd.**::*Nintendo*Wii*::*Modchips*::*W asabi*V3*Modchip*Bundle*(Wasabi*+*V5*Wiiclip*+*Tri wing*Screwdriver)
If i buy this is this just a clip on or does one wire need soldered?
also if i decide to get someone to install it would be you Spik seeing as if i live about 20-30 min away from Orlando (winter haven)
If you have a d2c2 and the chip is programmed to the latest 2.3 firmware, you should not have to solder anything.
Hey ciro thanks again for all the helpful replies. If I just open up my wii now is there anyway to tell what type of wii I have?