I'm buying the D2pro9 v2 without the clip and going to solder it myself, it'd still work right?
yes it will still work without the clip ,
Originally Posted by Skyre
Thanks in advance for any help you can give this noob.
My serial # is LU346128062
The serial generator says
50% chance of GC2-D2C
50% chance that pins are not cut
Can anyone advise what chip that I should purchase
and any recommendations on where to check?
Thanks again for any help one may provide.
My ser # is lu580 so i beleive i need D2PRO9 is there anything else i need to now i dont have a tri-wing to open yet but is it save to order this chip an what firmware thank you
bump mine is also saying 50/50
with LU348, chip says DC2.
i dont know why wii tracker always says "50% chance that pins are not cut" ....this always confuses users....if you bought ur wii after august 2007 then u pretty much have a d2c
the d2c2's started appearing at the beginning of april '08 so if you bought ur wii on april 1rst or higher it is guarenteed u don't have a d2c. u probably have a d2c2 and much later, a d2e.
I got mine last week, had to return one because the screw was stipped and I couldn't remove it. /wink
Originally Posted by smasher164
Then what is the serial cut-in for the d2e?
Originally Posted by GMODZ
I have a LU349 Is that a d2c2 or d2e?
it depends on when u bought urs, nintendo tries to confuse some people from identifiying their wiis by adding lu3's to the ones they made in july. but we have outgrown that so i think u have a d2c2 because u have lu3 and u bought ur wii later.
If u had like LEH then u probably would have d2e.