Wasabi DX using as Zero: red light blinking. Help

kimqwerty · 08-12-2009, 02:11 PM

Hey guys,

I'm new here and just bought the Wasabi DX. I installed it, tested it with a few backups (all worked), and then upgraded it to 2.0b. As soon as I finished upgrading, I turned off the Wii and tried to install it as Wasabi Zero (no ribbon cable, and I have the Wii Clip).

But with it pressed against the chip, when the Wii boots, the drive won't even start. All I get is a red flashing light from the Wasabi. What does this mean? Anyone can help?

Thanks!

pj2001 · 08-15-2009, 09:16 AM

Why? What are you trying to gain by installing as a zero (apart from 6x read speed) but that only affects the video in about 3 games. Not worth the hassle.

Ysu · 08-20-2009, 03:49 PM

No idea if you solved your problem yet but the Wii Clip to WasabiDX might not be aligned correctly. I had a red flashing light next to a green light when I installed my DX as a Zero. The drive didn't work as well. After making sure it was aligned correctly, it stayed green and the drive works.