hiya i got a wasabi dx for my wii,the person who put the chip in has done loads before,i get a black screen with the error eject and refer to manual and cant read disc,the dvds that im using are tested on another of my wii and work fine and has a wasabi in too,please can some1 help me,the guy said the jumpers are set to what it should be.i bought the product from electronic elite part of the hanger site.
hiya i got a wasabi dx for my wii,the person who put the chip in has done loads before,i get a black screen with the error eject and refer to manual and cant read disc,the dvds that im using are tested on another of my wii and work fine and has a wasabi in too,please can some1 help me,the guy said the jumpers are set to what it should be.i bought the product from electronic elite part of the hanger site.
once again, this is the wasabi zero forum not the wasabi dx forum. please post in the correct forum in the future. a cant read disc error sounds like a bad burn. if the same games work in another wii then find out any differences that exist between the 2 wiis. the games that dont work are backups correct? u mite need to have the guy who installed it go back over and recheck everything since u urself did not do the install. i would also hold him accountable for fixing it. its kinda hard to give u advice when ur not the one performing any of the tasks.
__________________ My Wii System
GC2-DMS Chipset - Wasabi Dx/Zero
3.2u Firmware - HB Channel - Bootmii as Boot2
Cios R14 - Neogamma R8B7
Linear Mode
