06-24-2010, 07:45 PM
yes, I got bootmii as boot2, I already bricked my wii a pair of times.... (because of some bad themes), and the bootmii was my salvation
But my question is : If the priiloader is active, Later the bootmii will boot?
06-24-2010, 10:53 PM
PriiLoader is nothing to do with Bootmii. They work independantly.
with the latest Bootmii there is is delay you can set in the bootmii.ini file. You can leave the bootmii folder on the SD card, it boots into bootmii then after the time delay, (say 5 secs) it then starts in system menu or HBC.
You can edit this manually, or there is a bootmii config program which works fine, both on boot2v2 and boot2v4.
1 User Says Thank You WiiJohn For This Useful Post
06-25-2010, 10:27 AM
Thanks great post
06-25-2010, 05:24 PM
can I get back my custom theme when finish installing the priiloader?
and what do I do once I get the hacks.ini? ow do I edit it? What do I leave in the hacks.ini?
Last edited by unrealtron; 06-26-2010 at 05:50 PM.
06-26-2010, 11:12 PM
Hello, i have a question.
Im already on firmware 4.2U (Installed with Waninkoko Firmware Updater 4.2)
I know 4.2 Firmware use IOS70 to run, my question is:
Can i install a patched IOS70 to run VC/Wiiware direct from SD Card and Install Priiloader v0.4 on 4.2U Firmware?
Its safe to install a patched IOS70 using Waninkoko Firmware 4.2U or i will brick if i install?
PS:I have a NAND backup of Waninkoko Firmware 4.0U and BootMii installed as boot2v3, but i dont want to brick the Wii ^^
06-27-2010, 12:19 AM
The hacks.ini file can be edited with notepad, then saved to the root of your SD card.
Only have hacks for your system menu in the file.
I don't know about your custom themes.
Install the patched IOS70 from first page, then install priiloader.
There are several guides on ways to run Vc/Wiiware, triforce, sneek, check these out.
You have a nand backup with boot2, relax.
06-27-2010, 05:02 AM
it says "canīt find Hacks.ini on NAND"
And all the lines are for my system menu
Last edited by unrealtron; 06-27-2010 at 05:31 AM.
06-27-2010, 05:38 AM
When priiloader runs it looks for the hacks.ini file in the root of the SD card.
Once configured and saved before exiting it resides in nand, so no need to leave the file there, but you can.
If it cannot find it, check the line breaks, use a file from this thread, I think it needs a space and return at the end.
06-27-2010, 06:07 AM
still canīt find it, I verifyed that theres a space at the end, and no spaces at the top.
06-27-2010, 07:03 AM
make sure its a SD card, and file is named hacks.ini, not hacks.ini.in.