Zelda Skyward Sword Help, I got it running.... In Game Issue
I got it working with cIOS 249  d2x v6 from the guide.
Game ran perfectly fine until I got to the first race on the birds, I begin the race ok and start chasing the thing.... then all of a sudden the controller stops responding and link just floats down, the game never stops or crashes but the controller is not responsive (controller light stays ON) to any buttons , including power, required a hard reset, tried again, same thing.
Wii is softmodded 4.2U with most recent USB Loader GX
Any help is appreciated.
Could it be a bad rip? Try re-ripping your game from the original.
Hi, thanks for the reply. I ripped it again (takes forever) and it is still happening. Very hard to troubleshoot since the game forces a 5 minute dialogue right before the race (at my save game).
Anyone else have this issue, or seen a game behave like this? (stop taking signal from wiimote)
Did you fix the issue?
I have had the same issue. Once I click on my saved file I enter the game and run around for about 5 seconds and the wiimote stops responding and Link just continues to run in the same direction, so my game doesn't freeze at all either. I am currently trying to download a PAL version of the ISO and trying to figure out how to change my savegame file to PAL. Just checking to see if any progress has been made on this problem yet.
Originally Posted by lowtek
played through the whole game no problems. used wiiflow
I just downloaded and tried using wiiflow and it loads the game as usual and my savefile was there, but my wiimote stopped responding the same way.
Originally Posted by roadofexcess
try cfg loader v70 and neoamma r9. if it still happens then its a problem with the game or your cios', let me know what happens and i'll see what i can do to help.
Only Site Donators Can PM Staff
Or you could have one of the new motion plus remotes that arent compatible.
Sent using the WiiHacks app. Please excuse the brevity, punctation, and spelling.
Thanks for all the replys
Originally Posted by cjizzle
I know for a fact that my remote works because I have played through about 1/2 of the game I am at the pirate ship in the desert and when I log in from my save file It just stops responding. I also tried to use cfg loader v70 and neoamma r9, but those did not work as well.
I have researched a little more and I found a thread elsewhere at this link: NTSC save file -> PAL - GBAtemp.net
If anyone on here could explain more in depth how to actually perform the steps 4-6 in that thread it would be greatly appreciated!
have you used the patch nintendo has sent out via wii shop? however you would need the same region game and wii. if not it might be a bit difficult.