Priiloader 0.5 (rev99) released
Currently version 0.5 has been removed due to an installer issue.
For now use version 0.4 rev78).
This is an official release, not a beta.
It works with HBC 0.7 and 0.8.
This installer/removal tool will install Priiloader v0.5(rev99/100 from svn , which is based on preloader 0.30 +
all other priiloader changes).
It is also capable of updating
any previous version and can be installed over the top of an older install. There is also
a removal option that will restore your system menu and clean all traces of Priiloader
from your system.
Press (+/A) to install or update Preloader.
Press (-/Y) to remove Preloader and restore your system menu.
Hold Down (B) with any of the above options to use IOS36.
Press (HOME/Start) to chicken out and quit the installer!
To access Priiloader and configure it please hold (RESET) during the boot cycle.
if run from HBC 1.0.7 and above, no ios patching is needed at all. however, if the installer
gives an option to reload to IOS36, and the user does this , then IOS36 needs to be fully
Priiloader itself does not need any ios patching (and we recommend to keep the system menu ios unpatched)
guide here, http://www.wiihacks.com/recommended-...e-0-5-r99.html
Last edited by WiiJohn; 09-12-2010 at 11:58 PM.
works like a treat mate cheers
^^^^^^^^pimpness from the mighty bmarlo ^^^^^^^^
does it need to be installed using IOS36 if not what is the benefit of doing so?