Try this guide. This is not a wiihacks guide but I have followed it myself and it is pretty good. A few small things missing but just pay attention to what you are doing and you will be fine.
I have a D3-2 Wii and am wanting to change my DVD drive motherboard to a DMS/D2B or D2C one. I'd just like to know, what is the disassembly and installation process like for undertaking this task?
After a bit of searching I've read some saying it's dead easy and some say it's complex as all hell, so I'd just like to know the truth from someone experienced with this problem/task.
Thanks in advance.
PS: The board I'd like to change:
Edit: I'm also willing to spend a little more in buying a complete replacement DVD drive if replacing the motherboard is too fidley.
Last edited by Lizardon; 06-02-2010 at 08:02 PM.
Sorry, oddgriffin, didn't look past the Wii board on where to post this. Shall know for next time.
Thanks for the reply and guide, Krafter. However, I've just realised that I should have been more specific about which board I'm referring to. What I'm wanting to change is the DVD drive motherboard (pictured below). As such, I've edited my original post accordingly.
Last edited by Lizardon; 06-02-2010 at 07:11 PM.
this guide which is a wiihacks guide (sorta). I shouldn't be that hard at the point to remove the DVD mother board.
(I should have read your original post more closely)
Thanks, Krafter. I've taken apart Wiis before an installed chips, so I'm right in disassembling the Wii itself.
After a little thinking, I've decided I'll just purchase a whole new DVD drive as it's a simple plug-and-play solution. Even though it's a little more expensive than buying a lone DVD drive motherboard, I do need to get a new soldering iron, and I'm not sure on all the technicalities in replacing the board. Plus, the time and hassle saved will be worth that little extra spent.
Thanks again for your help, Krafter.
PS: Just in case anyone is curious as to why I want to replace my drive/motherboard, it's because, as we know, the D3-2 drives can't play backup discs, and in order to play backed-up Gamecube games at the moment, discs are the only way. Yes, I know there's the WODE for booting Gamecube ISOs, but it doesn't support streaming audio, and for many Gamecube games, a disc is needed, thus requiring an earlier drive than the D3-2.
Edit: After a little more reasearch, replacing the DVD drive motherboard is relatively simple and is compatible will any drive (as they're all the same generic drive). It requires unclipping three things, undoing two screws and desoldering (or at least melting the existing solder) then resoldering (or melt the soldered points on the new board) 6 wires. Here's a couple of quick videos on the general process: Wii DVD Optical Drive Logic Board Replacement Tutorial and How to install Wii replacement board. I may consider this option now that I know it's relatively simple and there are no compatibility complications.
Last edited by Lizardon; 06-02-2010 at 11:02 PM.
I think cracking it open is easy enough, if i remember rightly you have to solder one place that is the bluetooth or [COLOR=darkblue ! important][/COLOR]wifi onto the mainboard. i cant solder but looks a piece of pie for anyone that can!