Need HELP!! D2pro
I have a DP2PRO and getting a current red light on it not going to blue what ment to do we have soldered 5 wires on it
the driver making weird sound cogs spins on drive whiel red light stays on
Have connected G,H,J and Ground, 3v3 wires as diragram shows
Last edited by gohan007; 08-23-2008 at 03:32 AM.
Ok i had look some wires re tested now theres now drive clunk sound, drive started up takes disk now, red light comes on the chip and now goes away but no other light comes up that still ok?.
I done the D2PRO 5/9 wire install used 5 wire not 9wire also used pic off the main website so i didnt solder D,E,F,C
Retired Staff Member
My understanding was that the 5 wire solution was for the DMS/D2A/D2B Wiis and all the others required the 9 wires to be soldered.
hmm k looking at that D,E,F must be easy way to pin thoose on hard enough to count along the board then solder that on
Last edited by gohan007; 08-23-2008 at 05:32 AM.
here is how the install should look like.. the 9th pin from left to right..
what didi you use hold chip down
the white thick ones..