Page 1 of 2 12 LastLast
Results 1 to 10 of 18

Thread: Wasabi 2 + Wii-Clip Install Video

  1. #1
    Reading Room
    Join Date
    May 2008
    Posts
    414

    Wasabi 2 + Wii-Clip Install Video

    How to install Wasabi 2 using Wii Clip. NOTE: D2C/D2C2 users will have to solder the F wire directly to the board in order for the chip and clip to work. DMS/D2B/D2A users can ignore this.

    [ame]http://www.youtube.com/watch?v=JUgw6rR-0ps[/ame]
    Last edited by GMODZ; 08-03-2008 at 09:22 PM.

  2. #2
    Member
    Retired Staff Member

    Join Date
    Jun 2008
    Posts
    1,494
    Nice video. Very helpful. Thanks.

  3. #3
    For noob solderers- I think this video misrepresents what the solder actually entails. I spent a good hour trying to solder my wire correctly, and I still don't think it's right. FYI- Don't be fooled by this expert. I still don't know how it's even possible to do it that fast. Where is the solder for the point on the clip? On the gun?

  4. #4
    Reading Room
    Join Date
    May 2008
    Posts
    414
    the clip is pre tinned and thats how we ship the clips...the video was obviously done by an expert so no1 should expect to do it that fast on the first go.

  5. #5
    I have a D2C and I'm planning on getting this, but do I have to solder the F wire directly into the board for it to work? I thought a Wii Clip meant no soldering -_-

  6. #6
    Reading Room
    Join Date
    May 2008
    Posts
    414
    yeah our new batch doesnt require any soldering ..its 100% solderless

  7. #7
    Could you provide a link to the solderless d2c wasabi wii clip? Or is it just the normal wasabi + wii clip setup? Cause I heard you still have to solder or connect some wires to the F wire for it to work.

  8. #8
    Reading Room
    Join Date
    May 2008
    Posts
    414
    with the V10 clip you do but if u use the v5b clip then u dont..we set it up for u so u dont have to use any wire

  9. #9
    Quote Originally Posted by GMODZ View Post
    How to install Wasabi 2 using Wii Clip. NOTE: D2C/D2C2 users will have to solder the F wire directly to the board in order for the chip and clip to work. DMS/D2B/D2A users can ignore this.

    YouTube - Wasabi 2 Clip
    how about D2E? thxx

  10. #10
    it's the same procedure. With the 100% solderless wasabis we ship out now, you can skip the wire install shown at the end of the video.

Page 1 of 2 12 LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •