Black Screen with Neogamma
I have quite a problem.
I tried softmodding a Wii from my friend (4.1E) and I did the following;
-First I used an old softmod tutorial, where I downgraded ios35, then installed a special ios35 which I had to load Wad Manager with, and then I had to install a custom ios wad.
Because my Wii freezed and my WiiMote turned off when I selecter ios35 I stopped following that tutorial and I used Doggeggs New 3.1-4.1 Softmod for ANY Wii tutorial on this board.
Everything went fine, without any errors and I double checked everything so I wouldn't forget anything.
But now I have a problem..
When I start Neogamma R8 my WiiMote turns off and I only get a black screen.
I tried installing Neogamma 7 that works fine on my own Wii, but it does the same.
So it doesn't even load neogamma at all, not just only the disk..
Can anyone help me further on this?
Last edited by Hrdstyl3r; 01-09-2010 at 12:14 AM.
Isn't there anyone that could help me out?
i dont know why neogamma doesnt work but u could try gecko os it almost as good as neogamma but the only problem i had was i couldnt get nsmb to work
i hope this helps
When you were following the guide from this forum, did you select wad install for the cios? I would go back and reinstall the cios in the guide, if you get an error, you will need to try the other guide to get a cios on a wii.
First I installed the Cios with a wad file.
Because that didn't work, I used network installation.
It said Custom IOS installed succesfully, but it didn't solve the problem..
I tried installing neogamma again, but that didn't work either..
Your probably in the same boat I am in with the new 3-2 drive. I get the same problem and have just went with the usb loader gx. I have many games on it now so it was probably a good thing anyway becuase I would have disks everywhere. I would recommend going that route and getting an external hard drive.
Are you trying to load from disc or USB Device??
Im trying to load from Disc..
But that shouldn't matter, because I don't even get a config screen.
My Wii just turns to black, freezes and the controller shuts down..
If you got errors doing the wad install your cios didn't install correctly. You will need to find the guide for how to get a cios or this will not be resolved.
I'm sorry, I said it didn't go right...
I meant that Neogamma didn't work then.. So I installed CIOS 249 with a network installation..