Page 1 of 2 12 LastLast
Results 1 to 10 of 15

Thread: destroyed point J while installing D2C pro9

  1. #1

    destroyed point J while installing D2C pro9

    i have included a picture of the point J that is highlighted in yellow. there is barely anything left to solder on, but i think i have found an alternative point and am unsure if its correct. the one highlighted in blue is the one i think is an alternative that i could solder too, but im not sure! could anyone confirm.

    Last edited by h4x0r911; 07-05-2008 at 06:45 AM.

  2. #2
    Member
    Retired Staff Member

    Join Date
    Jun 2008
    Posts
    1,494
    Just curious, why do you think the one circled in blue could be used as an alternative?

  3. #3
    i used a continuity tester and using what ever little piece of copper left its showed that they are connected. also the trace on the board.

  4. #4
    Anyone? Plz

    **bump**

  5. #5

  6. #6
    New Member §piktsµ's Avatar
    Join Date
    May 2008
    Location
    Orlando, FL - USA
    Posts
    548
    if you follow this set up below then u should be good



    Good luck..

  7. #7
    Quote Originally Posted by §piktsµ View Post
    if you follow this set up below then u should be good



    Good luck..
    i can't see that pic!

    NVM i just had to sign up for that site now i can see it.
    Last edited by h4x0r911; 07-07-2008 at 10:09 AM.

  8. #8
    New Member §piktsµ's Avatar
    Join Date
    May 2008
    Location
    Orlando, FL - USA
    Posts
    548
    Okay, try this one:

  9. #9
    thats not the thing, point J is destroyed! i need an alternative point!

  10. #10
    New Member §piktsµ's Avatar
    Join Date
    May 2008
    Location
    Orlando, FL - USA
    Posts
    548
    Then use the 7th leg on the chip set..
    as shown on gastro54's picture..
    That's the alternate point for J..
    Begin counting them from the top to bottom..

Page 1 of 2 12 LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •