have a question about my wii clip V14 presoldered Wiikey2 with yellow sticker.
I will be attaching it to a D2E chip.
The instructions advise me to cut the D, E & F traces.
Here's the question:
Am I supposed to cut the actual trace on the board (see arrow on Picture labeled 'B') by scratching through it, or am I supposed to cut through the solder blob right next to the chip (see arrow on Picture labeled 'A')
you can cut those tracks but the chip will work without cutting any of the tracks on a D2E drive, so just fit as is. if you do want to cut then it is the tracks you cut not the solder blob.
Drivekey Flatmod WasabiDX Wiikey2