Wasabi Zero solder install and games issue
just finished soldering the zero that I got from modcentral. Steady green, Original plays, Wasabi 1.4 config plays ok, and regular US NSTC backup played ok too (DDR2) However, I am not able to play any of my Jap region backups, they show up in Wii Chanel but goes blank after you click start...
I have D2E and 3.3u. Also enabled update blocker via config disc for both regions. Used Verbatim dvd-r and burned with imgburner at 4x and 2.4x. Same results.
also just tried need-for-speed, NTSC/USA, same results...
any ideas what's going on here? Do I need to patch iso using wiiupdateblocker?
Last edited by webada; 01-26-2009 at 12:39 PM.
if its fake signed it wont play
some out of region dont work
and try installing Cios 37 could be a ios issue
Thanks, I will need to read up on how to do that. This is totally new to me, my first mod and soldering a modchip first time, so I'm hoping its not because I screwed up the install......
Is this because of Wasabi Zero or 3.3u or just for certain games?
my friends with older firmware and wiikey don't see to have any of these issues.
Another words, would i have been better off with wiikey2 vs Zero?
Should I also consider downgrading to 3.2?
Last edited by webada; 01-26-2009 at 01:00 PM.
its like what i said wasnt even read =\
I understood what you said, was just trying to understand why the same disc would play on older firmware wii with wiikey but not mine with Wasabi.
3.3+ blocks fake signed
and IOS installed difference -.- the fact you didnt figure this out if proof you put no effort into looking into what i said
I guess i should have read your glossary instead of tutorials, most of them teaches how rather than why... lesson learned.
Originally Posted by admiral victorinox
you should ALWAYS know why, not how
Originally Posted by webada
if you know what, and why you need it youll ALWAYS know how to do it, though ssearching