Do as Joostin said this happened to me too when trying to install prioloader .5
Thanks you for this great thread! Very well done
For those who had problems with the md5summer.exe, it would not run on my pc.
I reformated my sd card a second time and everything went ok after that.
Hope it helps some people.
I got to the Nand back up and it started fine, processed about 2/3s then stalled. what do I do?
I took the sd card out and did have the
Files, I Saved them to my PC. I hope this was ok?
Last edited by krazynewf; 01-03-2011 at 08:55 PM.
The guide is going great - thanks so much for the step by step!
I'm about to install PriiLoader, but during the WAD Manager installation portion, it says there are 48 wads to install, but only 24 of them installed...the other 24 did not. I've noticed that the ones that didn't install share the same filename as the ones that did, only their filesize is only 4KB (4,096)...which is tiny in comparison to actual wad files.
Can anyone confirm that I can proceed with the installation of PriiLoader? The guide says if I don't make sure that all files install correctly that there could be problems with bricking...
How many files should be installed?
Last edited by jsoul780; 01-03-2011 at 08:58 PM.
wow i went through the steps and worked perfectly on my cousins wii thank you
i have a 2 questions though ..
1. how do you do the priiloader brick/ update protection? i tried holding the reset button as i pressed the power button ..and nothing??
2.my nephews updated their wii when they were on 4.2u.. it didn't brick ..so would i be able to use the 4.3 guide to softmod? or should i just restore to factory settings?
thank you for your time
ooooh ok i had got lost on that part thank you
i will try it out on their wii when i do it.. i just wanted to make sure it was safe to do so before i did the 4.3 guide
one more question
for my wii i have 4.2u softmoded , everything works well..
should i stay where i'm at ? or should update the soft-modding somehow ?