Don't know. I can test it tonight
Sent from my SPH-M930BST using Tapatalk 2
I'm attempting to softmod one of the newer model wii's that are blue, running 4.3u using the Smash Bros mod. I've modded several wii's in the past. When I go to install the wad's, i get unknown errors for them. Occasionally it will install the first 2 wad's, then get an error and stop. I tried switching to ios 236 and installing the wad's that way, but get the same errors. Any help would be greatly appreciated. Thank you!
I tried with d2x v9 (beta) and the old school cios38 17 and no luck. We tried two other HD's (new) with all 4 loaders and none will initialize or read the HD. None of the loaders will boot after selecting the start tab. I'm thinking the loaders are the ones that are not working properly. Can I remove them and reinstall them? How about restoring from my NAND back up and start again?
I'm loading the loaders from the SD card. I have no idea how to do a system check but I'm sure I can find it by searching.
Thanks for taking the time to respond.
Will try removing them and installing only one loader (need at as simple as possible). The kids don't need all these loaders. Nothing else is plugged in to either wii. I haven't tried loading apps from a usb. Will get back to you. Thanks
Maui... I got it!!! I removed all the loaders. Ended up installing some wads I had on an older Wii card (ended up installing like 45 wads...lol) and installed only the USB Loader GX from this guide on you tube... Thanks Maui!
I got this section of the softmod but now I do not see the priiloader link anywhere after I launch the Homebrew channel. The first time I launched it, I saw the 2 options for Priiloader and selected the first one. However, when I pressed A after reading the warning, nothing happened. So I held reset for a while but again nothing happened. So, eventually I turned off my wii and now when I launch the homebrew channel, I do not see the priiloader anywhere. Please help!:dft002:
You should be in the Homebrew Channel
Launch Priiloader (the first one is 0.7, the second 0.8 beta 4)
Priiloader Installer will load
Read the warning- Press +/A to install
When finished the HBC should load.
Hold reset on the wii console, keep holding reset - priiloader will load
****If the wii freezes, hold the power down for 10sec.****
****Only install priiloader once, you need to hold reset to load priiloader****