With all due respect, with any guide on a site with hacks in the title, a baseline (minimum) level of technical savvy needs to be assumed. Should you fall short of this requirement, or feel as though you might, it might make sense to find someone who doesn't fall short to assist you.
I'm in a big need of help!
I tried following this guide and everything works great until chapter 2, part 1.
I install all the WADS, and as far as i can see, all of them checked for ok. But when it was all done my wii controller had stoped working. I try powering it on but it wouldn't connect to the wii. So, me thinking the WADS were already installed, I shut of the console manually. I turn it on again and my wii remote still wont work. I try to synch it the manual way but it still get any signal from the wii.
hello, i just succesfully modded my 43.u wii this morning. thanks! however, when i change usb drive, open usbloadergx it says error #001 or usb device not found. when i put back the first usb everything working fine no error. is there something on usbloadergx setting need to be change as far switching usb drive or hard drive?
GX, or any usb loader for that matter aren't really built for drive swapping when the two drives aren't formatted the same. Try making sure the formats and partitions are the same on the two drives first. Aside from that, the only solution that I am aware of would be to delete the GXglobal.cfg file every time you want to change to a different drive---not the best route to go IMO.
i install cIOS249-d2x-v6.wad as per the error code guide but still usb device not found. they are formatted with wbfs partition. what does GXglobal.cfg do?
heres a little experiment i did.
i install the old usb loader gx r932 files and delete the files and folder on usbgx r2.3...to tell the truth it worked. is there a harm on doing this?
the gui on usbgx2.3 is too fancy unlike the gxr932 is simple. but it works..now i can play games on the other usb drive.
I have a quick question that hopefully somebody can help me out with.
After following the guide, everything works until I try to play my backup of skyward sword ripped to a usb HDD from an original disk.
Loader GX and Wiiflow continually give me the error #001 unauthorized device message - I've tried all the possible recommendations on the boards such as changing the ios from the launcher or executing via player.dol but to no avail.
Neogamma and Configurable Loader both work fine however.
So now I am more concerned as to whether I have done something wrong myself that is causing incompatibility or whether it's the combination of softmod software versions and the game itself.
I've reinstalled all my wads and gone through the softmodding process a few times incase I stubbed my ios's but that also made no difference.
Help would be greatly appreciated - thank you :)
I've followed the guide perfectly with no hiccups or issues but once I try to boot a game from a disc using Neogamma I get a disc read error (DVD+R/bad burn/DL problem?) I've soft modded someone elses Wii almost a year ago and the games worked fine. Even Skyward Sword. But now they wont seem to work on this Wii after the modding. Even regular non burnt games wont read from the main disc boot menu. What did I do wrong?
Sounds to me like a laser lens issue. Could be dirty, or could need replaced. The softmod does not affect anything that would stop retail games from being read. Try cleaning the laser to start. Did you do any other mods to the Wii before this one? If not and you bought the Wii second hand post a syscheck.