Ok, today i tried again. (FYI yesterday i loaded a lot of games with no problems.)
the 1st time i started the Wii and loaded the usb loader and the black dump screen appeared :-(
i resseted the Wii (holding power button) and tried again. same.
Reseeted again and now disconnected the HDD. When loader asked for HDD i put in usb and black screen again.
waited now 60 sec and Wii started again, started loader and to my surprise it loaded, i started 1 game no problem.
then i pussed home key to return which automatically loads the loader again and there was the black screen again.
The games do not black screen, either they load or loader freezes on pushing start button. this happened a lot.
yesterday i loaded games with no problems for about 2 hours.
Today I get a lot of dump screens when loading the usb loader.
Edit: i tried to load syscheck with the USB attached and is crashed, black screen??? same when i tried again with HDD disconnected
when you say you used mauis guide, did you follow it correctly and completed it to a "T" with no errors?
Did you accept an update at all from disk or internet? are you sure?
What is your hdd formatted to? is it even on the compatibility list?
Yes i followed the guide to the letter and no problems with that, than the HDD problems appeared and i read her to update the dx2 see sysdump above.
Originally Posted by Shift_Lock
only update i did was the usb loader over the internet.
HDD WD my passport 320 (is on the list) and formatted to FAT32. WiiMC plays with no issues at all from the HDD
ok.. delete your loader along with all the config data on your sd card and follow the link given to you here to reinstall and report back
Originally Posted by greeknl
Originally Posted by playerkp420
ok, i followed the guide. installed also the forwarder channel. BUT the ios58 will not update. it downloads ok but failed on installation.
Plugged in USB and run usb loader from channel - ok,
updated all covers - ok.
started a game - ok
exited to wii menu and started usbloader again - ok
trying to chsnge setting and it froze
resetting wii - start loader - ok
changed settings and saved -ok
after some restarting it seems that the loader starts ok but on a lot of games when pressing to start the loader freezes
does this have to do with the IOS58?
Whne i start HBC it says in the right top corner 1.0.8 IOS58 v24.32
And THANKS for the time you put into my problem
I downloaded this ios58 and installed it (see post #75 page 8)
still the same problems it freezes when starting games
Also how do i know with what ios to load a game?
The loader will freeze on games that are running on the incorrect cIOS.. as long as the loader boots up fine we have a good start..
boot up the loader>>> find a game that freezes>>>Select game with (A)>>>push (1) >>> Change the IOS it runs from (might have to try a few)>>>> push (2) to save and try to load the game.
and Im talking about the game setting not CFG's global settings...
Well i stumbled on something strange here.
after some trial and error i found out that when the USB loader (and most probably also HBC) is started with the nunchuck attached it goes wrong for me, dump screens and freezes. when i disconnect nunchuck and start usb loader all seems to load ok. Also when leaving a game, which on my system returns to the USB loader, i have to unplug the nunchuck for all to go ok.
lol thats normal... I spaced on that...... :p
So what you are saying is that I have no problem and just load usb-loader and games with nunchuck disconnected and all OK?
LMAO! Yup.... hahaha and if you come up with an issue try different cIOS to load the game from in the game options.. lol.. If you need more help we are here..