D2Sun v1.5 Flashing blue light but then what?
I recently purchased a delightful chip of this kind presoldered. I installed it without problem ... or so i thought! All seemed ok the pins didnt become bent, i set the jumper accordingly. I use a d2c chip (PAL) so i had them all switched down, the wire i sticked accordingly with electrical tape. I tried switching it on and a blue light appeared. I assumed this was correct, i then closed it back up and burned 3 different discs all on 4x speed using nero. The problem is, when i turn on the wii the chip (or outside bi is all i can see) flashes blue, it continues to do this until i go to the wii disc on the menu, it is then the chip blue light dissapears, and i get the - Cannot read disc, refer to manual.
Ive tried this now on 3 discs, and i cannot work out where i am going wrong, as i continually check how to install and see nothing wrong in what ive done.
Any help would be greatly appreciated.
According to wii chip test my drive is 100% d2c.
Many thanks for your help on this one.