I can run "ARC 1.1b mod06 Offline for 4.1JUEK" using IOS16 but get this error message:
After that, ARC loads and confirms "IOS: 16 with ES_Identity patch" but then gives the warning "WARNING: AREA/SysMenu MISMATCH". The console area is "USA", the game region is "USA", the Shop country code is "49" (for USA), the services EULA is "Read", but the System Menu 4.1 Installer says "Installed Region: ." (It's going to be challenging trying to Google a ".")Code:
Identifying as SU...OK!
Initializing Filesystem driver...OK!
Error! ISFS_Open (ret = -102)
Error! ES_OpenTitleContent (ret = -4)
Warning! Can not read you wii region.
Anyway, under the System Menu 4.1 Installer heading, it does say region "USA". I've tried to Set&Save, but no help. I did try to install System Menu 4.1 from within ARC -- probably didn't need to try since I'm already on 4.1U, but it didn't work anyway. Some ISFS error core similar to the one above.
Meanwhile I can't actually run any Wii games. Either when loading or upon inserting a disc the Wii eventually goes to the black "There has been an error" page. I think your hunch was right, either the EULA and/or the region isn't making my Wii happy enough to play.
A quick test of Wifi: if I tell it to scan for Access Points it will list local Wifi networks. Wifi is functional, it's just being denied by the Wii. When I try to configure it gives error 110213.
Any other insights mauifrog?
I did not mention that my Wii's DVD drive is a replacement from way back when the original one died (150 pounds of dust makes Wii sound like prop engine.) I used to know the drive type, I can find out if you think it matters. It had worked for WiiHacks in past though.
Sorry for replying to myself...
I ran ARC mod06 with IOS36, seeing that it was ES_Identity enabled like IOS16. I figured I would just "look" and not change anything. Anyway, it identified System Menu 4.1 region "U" instead of "." as seen by IOS16. Perhaps some magic IOS can rescue me when trying to play games and such? :-)
Yes. It was marked "read" when I loaded the ARC page. (It remembered.)
Okay I used ARC on IOS36 to mark EULA "unread" then saved. Exited ARC, reloaded ARC with IOS36 and it still said "unread." I hope that's what you meant read from settings?
I rebooted holding down reset to load priiloader, then disabled all hacks, then rebooted to system menu. I went to Wii Internet settings, ran test connection for the Wifi I had set up and it gave error 110213. I then went to "User Agreements" and said "Yes" (gasp) for WiiConnect24 and Wii Shop, then it sent me to Internet connections which failed again with error 110213. I then ran ARC on IOS36, marked "read" and saved, then repeated the Wifi connection test which still failed with error 110213. Hope I didn't go too far trying things, I just wanted to try to save some of your time before posting back. :-)
Could be bad wifi module too.
Or you could try converting a nand with betwiin
I don't know the reason for your disc channel not working (other than possibly a bad drive). I have had a similar wifi issue where the Wii would see all the available networks but couldn't connect to one. It turns out that you only need one antenna connected to the wifi module to do a scan however you need both antennas functional to connect to and use the wireless connection. I did the old tug test on both antenna wires and found that one came right out of the connector with little force. Replacing the antenna fixed the issue as the wifi card itself was working fine.