Solid Red Light
I am having issues installing d2pro9 with wii-clip. I am just getting a solid red light. My drive is d2b with cut pins. I have tried re-seating the chip a few times and I checked to make sure that no pins on the clip are bent. I am sure that the chip is seated correctly but still red light and dead drive.
Any ideas guys?
Originally Posted by mashedtaz1
- check to see if clk jumper is soldered...and if it is not working then unsolder it it... then run and solder the "j"wire
can you take a pic, make sure not all the connections are soldered to the clip, there are only certain points that should be , the rest should be blocked off.
only 3v3/gnd J, G, H should be soldered
I got the same thing the light stays red and the drive is dead won't eject so i remove the chip/clip and it wii works fine can the chip be soldered into the wii without the clip? I'm giving this as a gift to my daughter and don't want to wait for an exchange
push it with more force
i ha th same proble i took the clip out and push it again with more force and it worked very well no need to oldr anything