Wiikey 2 Blue LED and No disk Load
OK this is my first post, and my first time modding a system... I know dangerous combination... I do preform component level repair for the military, so I am happy to say my soldering skills are above average... although I did make small error on my first attempt. :o When I first ran up the system I got the red LED only and the drive was inop. when i disconnected power from the wiikey chip the drive worked and the Wii acted normal. When I first soldered my Wiikey 2 up I left the iron on point G (I have read this is a clock input) a little too long so the solder point came free from the drive board. I assumed this was my problem so i re-soldered this line to the second leg on the chip. and tried again. This time I on power up the red LED flashed then the blue LED came on solid and the drive still does not work... I am lost... Is there a way to troubleshoot the chip? I would love to know if Im starting out with good hardware or not!!!
I have a yellow sticker Wiikey that I got from canandamods. A D2C chip and I'm using the 6 wire hookup... I will post pics here in a few. Thanks for any help in advance!!!