SNEEK v2 - Pre-made SD light installations
These should help people get SNEEK running. Please report back on how you get on. Backup your NAND and SD card first.
Just extract one of these archives to your SD card. You should end up with the following folders in the root of your SD card: apps, bootmii, import, meta, shared1, shared2, sys, title, ticket, tmp.
Inser the SD card into your Wii. You will need bootmii installed to your Wii to get sneek running. If you only have bootmii as IOS then you will need to go to HBC and choose "Launch Bootmii". Otherwise, if you have Bootmii as boot2 then just turn on your Wii with the SD card inserted to launch SNEEK.
[spoiler]This pack contains a very light SNEEK installation. Here's an example of the readme included with each archive
<<< SNEEK Side >>>
boot2.bin (with read from SD enabled, and usb gecko output disabled)
<<< Wii Side >>>
Systemmenu vXXX (3.XX)
HBC Installer Channel (see Note 4 below)
<<< Apps >>>
GrabDeviceCert (cannot be run successfully from SNEEK)
<<< Notes >>>
(1) boot2.bin has been modified to have SD access (any homebrew that attempts
to write to SD will crash)
(2) setting.txt is a XXX version, modified to give a serial number of 555555555.
See /title/00000001/00000002/data/setting_decrypted.txt for details.
(3) HBC will show a scam screen until you follow the instructions in
'/sys/device.cert.txt' (or see Note 4 below)
(4) If you want HBC to work with your Wii serial number then use the "HBC
Installer Channel". First, delete HBC using ShowMiiWads or AnyTitle Deleter.
Then place boot.elf from the HackMiiInstaller into one ofthe following locations
(Will not work on USA version of systemmenu):