d2pro on a d2b problem
I soldered the 5 pin D2B install with a d2pro chip..
Constant red light and no drive motor working.
soldered g, h, j, gnd, 3v3.
What is my problem... :o
Hope these pictures help.
the soldering isnt that great so that could be a reason, but lets approach the other possibilities. Is the d2pro9 a revision 2 or is it the first one? if its the first one is it updated to 1.1b yet ? If its not 1.1b then that is why its not working.
ah ok.... I dont have a programmer yet....so, i am not sure what version the chips are.
Its in the post.
Its funny, i thought the soldering was the best i did yet lol...but i only chipped 3 machines :)
1 with a wasabi chip. The other with one of the d2pro chips on a D2C chipset(worked fine) and this one(d2b)...
Soldering looks ok. What do your leds do on start and afterwards?
Spyman hit the hammer on the nail with suggesting the version number. I upgraded the chip to v1.1 using a d2prog and it worked!