Novice solderer needs advice(WASABI)
I recently tried to install my wasabi chip on my d2b drive. Everything went pretty well until I tried to solder my final wire the the optical drive. I somehow sucked all the solder off the solder point, and oxidized ( or maybe slightly burned) the solder point. A solder diagram is available Here.
The point in question in the "B" point on the drive. I cant get a wire to attach to that point. Can i solder a wire to the point directly above the correct solder point shown in the above picture? Or can I dremmel out the area, and attempt to solder then? Will this mess up my circuit board? Does anyone have any other suggestions? I will try to include a pic later if my description sucks. I'm located in denver,colorado if you do installs- I would be happy to pay at this stage in things.
The drive still works fine- reads disks w/o a problem, so i haven't damaged it to that extent, and i would prefer not to.