Seeking help/advice with D2CPro/WiiClip install
I've just installed a pre-soldered D2CPro/Wii-Clip into my machine and need a little help.
Upon installing the chip, the machine reads and plays original discs fine but not backups. I'm speculating as to whether these results point to a faulty backup/burn. My first assumption was that if there was a problem with the chip and/or it's installation, the console wouldn't work at all, original disc or otherwise. Is this sound reasoning or not?
I've only ripped one disc so far, burning it once with Alcohol 120 and once with Nero. Same results both times. The rip was done with RawDump and the resulting ISO file seems OK. One thing I have not done is use the recommended brand of blank media, using instead what I already had around.
As far as the install goes, I'm fairly certain the clip is properly seated. It took rather firm pressure but the thing is really on there snug and flush so I doubt there's an issue there.
I have a few more variables to rule out, but I thought I'd start looking for some assistance right away. Thanks in advance for any help you can offer.