"Sorry no d2pro chip found"
Ive been searching online for a couple days on this one and can't solve it myself.
I purchased a wiiclip2 with d2pro9 v3 attached in early July 09. Whenever I load the utility disk 1.7 I get the message "Sorry, no d2pro chip found".
It was suggested that I burn using verbatim -r manufactured in singapore with ImgBurn at 4x. Ive tried burning as low as 1x yet still get the message.
I have used two different kinds of media (including Verbatim -Rs) in two different burners on two different computers.
I openned and reseated the chip on the board and tripple checked the clip was evenly seated.
The backups all boot fine, and was able to load a homebrew GCOS based disk without a hitch. The LEDs follow all the typical patterns that would indicate it is working properly, I just can't configure it.