Ok...don't know if this is a bad or good news...but i unscrewed my GC controller held down the four keys started the Wii and i got the version 4.1 USA in the right below corner.
Kept on holding and nothing happened...
So now what?
The topics are so complicated can't even relate what I'm reading with my case....
does your dvd drive support burned disc loading?
Did you install the wads from the sotfmod any wii guide?
Yes i installed all the wads which i downloaded from the topic subject "soft mod any wii"
Regarding playing hacked games...hmm...now i don't have any disc to try it out, but if it helps YES i used to insert discs and go to the disc back up channel to start a backed up game.
The game will never start if i inserted it and clicked on start in the official DVD channel...i have to click the start in the back up disc channel.
Thanks for the PM!
Tried to reply you but couldn't send you the PM...
I assume i will have to dowoad all these files in the mediafire and burn it on a disk...
Then download the region frii files and put it in my memory stick correct?
Again thanks a lot for helping!
Use regionfrii to change to iso region to USA.
also use wii iso renamer v3, change the title id to 0SBE
Burn on good Media. Dual Layer media, such as verbatim dvd + or minus. I have had good luck with verbatim dl dvd +r 8x and verbatim dl dvd -r 2.4x.
Burn with ImgBurn, @ 4x set the layer break to - 2084960
Then download smash stack pal and extract it to your sd card. Change the title id of smash stack pal from RSBP to 0SBE, found in the private folder.
Do savemiifrii, put the disc in, run the smash stack. Use it to load the hackmii installer (put that boot.elf on sd:\ also). Install the HBC and exit to the HBC.
Then reinstall priiloader 0.7.
If the disc loads to blackscreen, try burning http://www.mediafire.com/download/12...tarfox-USA.zip and loading that via savemiifrii (just to test game loading).
Thanks a LOT!
as I'm traveling today i will do the whole thing after 2 days...
Over and over thanks a lot!
But just to make sure, ...if all went smooth I'd be back to the same old state...Priiload installed...what to be done from that point? Or after this the wii should work normally?
Keep in mind that my remote and my wii doesn't sync...
Right, so possibly these game disc will not load, which could be burn related. However, games don't load with a bad bt module, neither does the system menu. If the games load, your wiimote and bt module should be working, then you can get priiloader installed and be in a position to do something with your wii.
Originally Posted by abboodeh
The bt module is suspect, no guarantees of course.
Crap, OK I don't think I was thinking clearly. Burn this iso, USA version. Then load priiloader via the app loader.
Originally Posted by mauifrog
Thanks i'm a little bit confused ...but will follow your latest advice! i just need to go buy some discs to burn the ISO...
Great! Used savemefri the disk booted now what to do...I'm so afraid to try anything so here's a screen shoot :