Help Needed: Wii NAND Backup Process Froze
Tl;Dr: What do I do with the SD card and its contents BEFORE I attempt to back up the nand again?
Hello. I have been following the Softmod ANY Wii guide, and have completed each step correctly. I formatted my SD card to FAT32 prior to getting started, made sure I had 500+ blocks of memory free on my Wii, and used the Letterbomb method of installing Hackmii on my 4.3U Wii. I then used Hackmii to install the homebrew channel, installed Bootmii as Boot2, and "prepared" the SD card, with no errors.
Then, while attempting to back up the NAND, the process froze at a little over halfway through. No messages popped up, it just stopped progressing. I held down the power button until the console reset. After checking to see that the console is still functioning, I removed the SD card so I could write down the specs and information contain on it here.
2 Gigabte SD Memory card, by Toshiba. I named it "Wii" during the formatting process.
bootmii (folder, with every black bullet being a file)
- armboot.bin (48.4kb)
- bootmii.ini (225 bytes)
- ppcboot.elf (310kb)
private (folder, with every black bullet being a folder inside the previous folder, except for the bullet aligned to the right of the others, which is a file)
nand.bin (0 bytes)
The issue might be my brand of SD Card, but I can't know for sure until I have tried to backup the NAND again. But I need to know:
What do I do with the SD card and its contents BEFORE I attempt to back up the nand again?
I do not know if it is as simple as deleting individual files, if the whole SD card must be reformatted again, or if the entire process must be started from scratch. The guide contains no information on what to do in the event of a NAND backup failure