mauifrog

I am have an issue syncing my wiimotes. I had two wiimotes and everything was fine. They both are on an energizer recharge station and would both sync, which ever one pushed the buttons first would be player one, the second would be player two. Ok so I decided to buy a third wiimote, it has normal bateries- I synced it to my wii, works fine. Now the problem is I turn on my wii and grab a wiimote, the old ones now sync to player 2 and 3- never to player one. I have to use the new wiimote to sync as player one, which is bothering me. I makes no sense to me, any ideas

LU65 wii with
wassabi dx
LU64 fix
New 3.1-4.1 Softmod for ANY Wii
4.1u, bootmii-ios, preloader .29, cIOS38 r14
some wads- everything works

Thank You

mauifrog

OK so I have been having this problem for a week now and I woke up this morning and the problem was gone.

__________________

joinx

don't let your wiimotes u dnt want to use in front of the wii and sync again..it will recognize the old one as new..then when using the two others sync normally..at least try this..

thucncao

well this happens to me every once in awhile as well. Its a pain in the butt. Its a fairly simple fix though. I found the fix to it when I was reading the handbook that comes with the wii. Im too lazy to type it all, so I got the links from nintendo for ya in case it happens again and it usually does.

1.Turn the Wii console power OFF by pressing the POWER Button on the front of the console. Unplug the power cord from the wall outlet for a few seconds. After a few seconds have elapsed, plug the cord back into the wall outlet.


2.Turn the power of the Wii console ON. When you see the Health and Safety screen, open the small flap on the front of the Wii console to find a red button labeled "SYNC." Press and hold the SYNC Button down for 15 seconds. This will clear all the syncs on the Wii, allowing you to get a clean start to begin the process described below.


3.After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:

•With the first Wii Remote you wish to sync, remove the battery cover on the back of the Wii Remote to find a small red button just below the batteries.


•Press and release the small red button just below the batteries on the Wii Remote; the blue lights on the front of the Wii Remote will blink.


•Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).


•When the Player LED blinking stops and stays lit, the syncing is complete. The LED that is illuminated indicates the player number (1 through 4).


•This sync procedure (steps "a" through "d" above) must be followed for each additional Wii Remote added to the system.

__________________

mauifrog

Thanks, I never did think to read that book.

__________________