D2x v6 is new and u should get it installed - here is the guide. As for the driver game if u have seen the list of problematic games then the solution is there.
Not been around for ages..... I think the last time it was to sort out black ops. seems like ages ago.
Well, It looks like I've been totally out of touch, as I have seen talk of this D2Xv6...... It's at this point that I don't have a clue about whats going on.
And I was hoping someone could possibly point me in the right direction as to what to do to get driver to run.
My wii is a 4.1E updated from within these very pages from 3.0. Using cfl (a very old version i think 56) but if it aint broke why fix it. 95% of my games run from external usb 500gb, all except cod3, (for obvious reasons) and now Driver.
Well Driver loads the introduction then goes to load the game and then just locks up, leaving you to do a forced reset.
I read the list of problematic games list. And it says Use d2xv6 base 57, could this be installed as a wad. or would i need to use something else.
If I remember correctly I used cIOS249-v19.wad for "cod bo", as it came recommended. i then changed cfl to use 250 (i think) to load it..... to be honest I may well have that totally to cock, but I know it worked. lol
Did D2Xv6 used to be called something else, as this is where I may be getting confused.
I could really do with a little help please chaps.....
Thanks to all for any replies and also for taking the time out to read this plea for mercy......
Thanks for the reply pob3008,
but do you know exactly what files/info it replaces on the wii?
Well that all depends on yourself, i have d2x v6 base ios 56 in slot 249 and base 57 in slot 248 and base 38 in slot 247 but u can have them wherever u like.
So would I be correct in saying that d2xv6 is a replacement for cIOS250 -v21, please tell me if I have this wrong, also is there a wad available for this d2xv6?
Thanks for the help chaps....
My original softmod was done using dogeggs guide from a couple of years ago........ So it looks like i'll need to update my version of cfg, and what i'm hoping is correct, for a pre-softmodded wii, to do this,
As I already have hbc 1.08, half a dozen nand backups, bootme as boot 2, and priiloader.
Do I just use this to update:
taken from here: http://www.wiihacks.com/recommended-...d-any-wii.html
CIOS Update v21d2x6
Download cios update v21d2x6.zip
Extract to sd:\
Verify Checksums if you like
Load the HBC
Load Multi-Mod Manager
Select Wad Manager
Select folder "cios update v21d2x6"
Press 1, Press A to install all wads
4 wads should install without error
When your away from the scene for ages it takes ages to catch up again....
That is a good route to go, but keep in mind in that guide the most compatibility will come from setting your loader to 248. FYI, since it has been quite some time since you softmodded your IOS may be a bit dated as well. You could fully update by following the guide you linked to from Chapter 2 on.