whats it take to get some help around here ?

regularcat · 10-04-2009, 03:02 PM

i know it says read tuts first & search, which i have done.
so i post a question & i get no response.

reading all this is great, but i am new to this & it makes no sense.
these tuts are meant to read as if the new people know what any of the stuff in it means.

i can hack & mod psp"s & xbox 360's all day.

so with that said CAN I GET SOME HELP PLEASE ?

i ran the 3.4 to 4.? thread & did it w/o updating to 4.1 & preloader because when i tried to install preloader it just froze my wii.

so i have hbc & neogamma r7 & they both launch, so great.

now the problems are on (3.4u)

1. neogamma launches but doesnt launch any of the games
(marvel ultimate alliance 2) but it shows me game id rmse25
but then just freezes (dvdx is installed)

how do i make the game work, obviously its burned properly or i wouldnt get
the game id info.

2. i couldnt install bootmii as boot2 so i had to do it as ios, i want to redo the whole softmod over in case something was screwed up, so i read the make your wii virgin thread & it says because bootmii isnt boot2 i shouldnt
do the following procedure.

how do i do it then, i dont want to brick, & there has got to be a way to do it.

TO THE FORUMS MODS, IF I GET AN ANSWER TO THESE 2 QUESTIONS I WILL DONATE SOMETHING TO THE FORUM.

i need to know how to get back ups to play, how to make my wii virgin on 3.4u w/o updating, or a way to copy my nand backup made with bootmii to make it virgin again & how to make my wii brick proof.

thanks in advance.

ShadowSonic2 · 10-04-2009, 03:09 PM

1) Have you tried different versions of NeoGamma? e.g NeoGamma R6 or Neogamma R7. Try using different cIOS249 revisions. E.g cIOS38-rev13b, cIOS38-rev14.

2)Since one of the steps in the make your wii a virgin guide is to update, it is currently not advised to do it since the latest update is 4.2, if you want to remove your cIOS, re-running the installer can do so and AnyTitleDeleter can help you as well if you're careful.

Tealc · 10-04-2009, 03:10 PM

Preloader will freeze your Wii on 3.4 because it's not supported. Go to 4.0, you'll then have preloader which will brick protect you. IOS60 patched followed by 4.1 Firmware updater and then Preloader.

Try an elaborate on your freezing issue. Is that a black screen? Strap screen? Title Screen? Mid game?

Your Wii cannot be brick proof as you can't use boot2 protection, preloader is close though and will be fine unless you do something stupid.