Just another question, What do i do with Jumper J1 as i have the D2B set ( on the page it says DMS short J1 (http://www.d2sun.com/D2SUN-Diagram_V1.3A.jpg)
Thanks for help
Im told to solder the pin K2 on.. Is this right and is On the pin at the top
Think i have messed it up now as the wii will not boot anything with or without chip..
It starts and drive spins but nothing else.
I think i bent one of the wires on that goes on the slot, Can these be removed from the clip and soldered to board
Thanks again Hybridkid
hi i have a d2sun ver1,31 and for the life of me canot get super bash brawl to work someone said it might be the chip, i have 80+backups that work fine never had trouble till now i have tried two different torrents,and burned dual layer and normal . the file is dvd5 and when unpacked is 4.37gb so should fit on normal dvd right! my wii is running 3.4e update can any one help please as i have enough costers already
To answer your question though, yes you can solder directly to the board, and that is the prefered installation method.
hi thanks very much for your help, i understand i will get the full version and try again
Hello i am new and my english not so very well,sorry
Ok this my problem i have a wii-clip V12b and a d2sun 1.3a on a D2e and wii serial is LEF1..... when turn the wii on i see first a red light flicker for a second and then go a green light on(on the chip), i think this must be good i have solderd all points on the wii clip and solderd K1 on, i think its PAL (buy in the Netherlands). When i inserted a game ( i have only try 2) james 007 qantum of slocace and hasbro family games by the first it say no dvd in and by the second game it give a error and say eject and turn power off, i burned it with 2,4 on imation dvd-r with imgburn and those games are downloaded with torrents in a iso format the size is good, so i hope somebody can help me as soon is possible thanks.
does it play normal games!
yes when eject the copy game and replace the orginal wii sports it works fine