+ Reply to Thread
Results 1 to 3 of 3

Thread: d2Sun v1.3a with wiiclip (jumper help)

  1. 02-25-2009 08:48 PM #1
    Sadistik82
    Sadistik82 is offline
    Junior Member
    Join Date
    Feb 2009
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Downloads
    0
    Uploads
    0

    Us d2Sun v1.3a with wiiclip (jumper help)

    I'm new to this hard modding so here goes. I recently purchased a Wii. Wiidrives.com says I likely have a D2b drive. So what jumpers do I have to solder on my chip to make it work? Also, PAL and NTSC? I'm confused.
    Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
    Reply With Quote Reply With Quote  
  2. 02-28-2009 07:29 AM #2
    ixtreme
    ixtreme is offline
    Junior Member
    Join Date
    Jan 2009
    Posts
    22
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Downloads
    2
    Uploads
    0
    ok...as your wiidrive is a d2b, you need to solder jumpers k2 and k4 only. (that is for USA version wii)

    The difference between NTSC and PAL is the frequency the display the image is shown.
    PAL is 50hz and ntsc is 60hz
    Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
    Reply With Quote Reply With Quote  
  3. 03-02-2009 06:34 AM #3
    Sadistik82
    Sadistik82 is offline
    Junior Member
    Join Date
    Feb 2009
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Downloads
    0
    Uploads
    0

    thank you

    thanks for the help. everything works beautifully now. I also bought a small fan for the Wii which plugs in the back, drawing off any excess heat given off by the chip.
    Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
    Reply With Quote Reply With Quote  
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules