Page 1 of 3 123 LastLast
Results 1 to 10 of 30

Thread: D2pro9 + Wii-Clip Install Video

  1. #1
    Reading Room
    Join Date
    May 2008
    Posts
    414
    Thanks
    0
    Thanked 1 Time in 1 Post

    D2pro9 + Wii-Clip Install Video

    Here is a video of how to install the d2pro9 and wii clip. This will help people get a general idea of how the chip and drive should sound if it is installed correctly.

    NOTE: Some D2C/D2C2 users might have to install the J wire instead of bridging the CK wire in order to get this working. Always try bridging CK first and if that doesnt work then install the J wire and UNBRIDGE the CK wire.

    [ame]http://www.youtube.com/watch?v=jNe_iQPLfqU[/ame]
    Last edited by GMODZ; 08-03-2008 at 09:23 PM.

  2. #2
    Member
    Retired Staff Member

    Join Date
    Jun 2008
    Posts
    1,494
    Thanks
    70
    Thanked 230 Times in 116 Posts
    Nice video. very helpful. Thanks.

  3. #3
    Junior Member
    Join Date
    Jul 2008
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts
    was this on a D2C or a D2C2?

  4. #4
    Member
    Join Date
    Jul 2008
    Posts
    320
    Thanks
    0
    Thanked 1 Time in 1 Post
    it was a d2c2 wii that chip/clip was tested on

  5. #5
    Junior Member
    Join Date
    Jul 2008
    Posts
    106
    Thanks
    0
    Thanked 2 Times in 2 Posts
    About the J and CK, if i buy a presoldered chip, do i need to worry about them?

  6. #6
    Member
    Join Date
    Jul 2008
    Posts
    320
    Thanks
    0
    Thanked 1 Time in 1 Post
    The CLK points will be bridged already. The J wire only needs to be used if you get the inching problem after installation.

  7. #7
    Reading Room
    Join Date
    May 2008
    Posts
    414
    Thanks
    0
    Thanked 1 Time in 1 Post
    high res video coming soon

  8. #8
    Junior Member
    Join Date
    Jul 2008
    Posts
    106
    Thanks
    0
    Thanked 2 Times in 2 Posts
    And what if i get a red light? v2 on old d2c

  9. #9
    Reading Room
    Join Date
    May 2008
    Posts
    414
    Thanks
    0
    Thanked 1 Time in 1 Post
    then you need to solder the one J wire as per the diagram below

    http://www.wii-clip.com/images/V4C_D2Pro_9wires-8.jpg

  10. #10
    Junior Member
    Join Date
    Jul 2008
    Posts
    6
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I had that problem on my D2C I unbridged CLK and wired J to J and now the red and blue flashes like that video but no drive spin up still? Any ideas?

Page 1 of 3 123 LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •