Printable View
Here is a video of how to install the d2pro9 and wii clip. This will help people get a general idea of how the chip and drive should sound if it is installed correctly.
NOTE: Some D2C/D2C2 users might have to install the J wire instead of bridging the CK wire in order to get this working. Always try bridging CK first and if that doesnt work then install the J wire and UNBRIDGE the CK wire.
[ame]http://www.youtube.com/watch?v=jNe_iQPLfqU[/ame]
Nice video. very helpful. Thanks.
was this on a D2C or a D2C2?
it was a d2c2 wii that chip/clip was tested on
About the J and CK, if i buy a presoldered chip, do i need to worry about them?
The CLK points will be bridged already. The J wire only needs to be used if you get the inching problem after installation.
high res video coming soon
And what if i get a red light? :) v2 on old d2c
then you need to solder the one J wire as per the diagram below
http://www.wii-clip.com/images/V4C_D2Pro_9wires-8.jpg
I had that problem on my D2C I unbridged CLK and wired J to J and now the red and blue flashes like that video but no drive spin up still? Any ideas?