Results 1 to 3 of 3

Thread: D2pro9 install help

  1. #1
    Junior Member
    Join Date
    May 2008
    Posts
    10
    Thanks
    0
    Thanked 1 Time in 1 Post

    D2pro9 install help

    OK I ordered a D2pro9 and wiiClip I got it installed but am not able to read any burned disks. Using verbatim at 2X. Console will read and play originals,get the can't read disk with burned. Tried a couple ISOs and the 1.5 utility disk same thing.

    So I opened it back up and applied power and I get a quick red, then a quick blue. I believe it then goes red blue red then all off.

    I have read that I should be able to darn near lift the drive with the clip installed, but that is not the case, I barley touch the clip and it pops off. I have put almost all me strength into it (6'6" 260lbs) and I am worried about cracking something.

    How can I tell if the chip is in fact working?

    I have a DMS and the CLK is shorted. This chip was ordered late June. Do I need to do an update of some sorts?

    Thanks in advance
    Snowman

  2. #2
    Junior Member
    Join Date
    May 2008
    Posts
    10
    Thanks
    0
    Thanked 1 Time in 1 Post
    Thread can be closed. It turned out to be and id10t error. I am really embarrassed to say that I dont play the wii that much doing the more for the kids and wife.


    Soooooooooo..... I was putting the disks in upside down. I would have thought it would have spit it back out.

    OFW! live and learn....

  3. #3
    Member smasher164's Avatar
    Join Date
    Jul 2008
    Posts
    441
    Thanks
    6
    Thanked 12 Times in 6 Posts
    d2pro : Home just released the alternative 2.1 firmware update today for the d2c users who are having problems with the d2pro! The wait is finally over!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •