Results 1 to 3 of 3

Thread: Is this D2Pro9 v2 soldered properly to the wii-clip?

  1. #1
    Junior Member
    Join Date
    Jul 2008
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Is this D2Pro9 v2 soldered properly to the wii-clip?

    I purchased a d2pro9 v2 chip presoldered to the wii-clip from modchipcentral. The CLK jumper was already shorted, but several legs on the chip were not soldered to the corresponding legs on the wii-clip, e.g. P, N, M legs were not soldered at all (please refer to the attached photo). I would like to know if it is supposed to be like this, or shall I solder them myself.

    I could email the seller, but they do not open on weekend.

    Thanks very much for your help.

    The photo showing the chip that I ordered can also be viewed here: http://img301.imageshack.us/my.php?image=d2pro9kw1.jpg
    Attached Images Attached Images
    Last edited by dakelv; 07-18-2008 at 05:25 PM.

  2. #2
    Member
    Join Date
    Jul 2008
    Posts
    320
    Thanks
    0
    Thanked 1 Time in 1 Post
    the other points dont need to be soldered if it using the current bios that supports 9 wire installs. The clip has the other points in case you use the older d2pro chips.

  3. #3
    Junior Member
    Join Date
    Jul 2008
    Posts
    2
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Thumbs up

    Thanks for your reply n1tro.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •