D2pro with WII-CLIP V4C-9A - problem!
I have a Wii with firmware 3.4e and chipset D2E , pal system.
Today I install in my Wii a D2pro 6 wire with wii-clip V4C-9A.
D2pro has HW 2.5 and SPI 1.7
I put pictures in my flickr here: Wii disassembling - a set on Flickr
I proceed with the instalation as I saw in the canadamods, everything went well and the modchip flash the red and blue chip without problems.
And read backup and original dvd's.
I tested wii sports original dvd, wario shake dimension, ravin rabbids tv and dvd utility 1.7 d2pro (all pal)
After testing the dvds, I start playing wario a few minutes then I wanted to tried another game.
I saved wario game, went to wii menu and eject the dvd (until here everything worked great).
Then I tried to put a dvd and the drive rejects (like you tried to push the dvd but the drive don't push it).
I put the Wii in standby mode and then I push the dvd and the drive push it and start reading, I notice that it's was trying to read but then it gave the "Unable to read the disc".
Then I eject and put another dvd, this time it's push it too but the same error "Unable to read the disc" -- same thing with originals and backups.
PS: I notice that the laser is trying to read and makes a different noise...
What can be the main cause for this? Have to solder the J wire (ground problems)?
UPDATE: When I opened wii and just took the case and nothing more I tried play games and it worked and no problems when I eject and put again another disc.. Isolation problem?
Last edited by vador; 01-14-2009 at 06:46 AM.
Didn't the clip come with a sticker to isolate the back and then the cardboard packaging isolates the front? this is what i did yesterday ... hope i don't need to perform anymore isolation fixes :-(
Yep it did!
But for me didn't work.
If you have problems like , your discs all work and suddenly no disc is recognize, can be an isolation problem.
If you haven't any problems don't worry
Last edited by vador; 01-16-2009 at 05:15 AM.