• DIOS MIOS v2.0

    by
    Red_Gh0st
    Published on 06-25-2012 01:46 PM
    2 Comments Comments

    DIOS MIOS v2.0 has been released by Crediar. DIOS MIOS allows you to run Gamecube games from an USB device on your Wii. This new versions allows the loading of GC games through USB. Not to be confused with DIOS MIOS Lite (DML).

    Features:
    Load Gamecube ISOs from USB device
    Load extracted Gamecube ISOs from USB device
    Load Gamecube Discs
    Emulate Memorycard (NoMoreMemory)
    Cheat codes
    USBGecko debugging
    Changeable configuration of various settings
    Reset/Power off via GC controller key combo
    Real-NAND and emu-NAND support


    Download DIOS MIOS v2.0
    Frequently Asked Questions

    Official Project Page

    This article was originally published in forum thread: DIOS MIOS v2.0 started by Red_Gh0st View original post
    Comments 2280 Comments
    1. 2Hack's Avatar
      2Hack - 07-10-2012, 06:12 PM
      Im on rev 58 and sa2 battle worked solely with neogamma...
    1. SNES_Master's Avatar
      SNES_Master - 07-10-2012, 06:26 PM
      Quote Originally Posted by jax

      That's because it doesn't use ios/cios to run GC games it uses Dios Mios.
      I was halfway kidding :P
      But I would've thought that USB Loading GC games would use some cIOS?
    1. cwjakesteel's Avatar
      cwjakesteel - 07-10-2012, 07:21 PM
      Quote Originally Posted by jax View Post
      After installing ios58 you would need to re-install the Homebrew channel.
      Does that also mean that if I install a new ios like IOS55, 56, and 57 I would need to reinstall the d2x for all of them?
    1. BMANN2's Avatar
      BMANN2 - 07-10-2012, 07:25 PM
      @cwjakesteel

      I tried what you suggested and unfortunately it didn't work. How are people showing these full system specs, maybe that can help if i get mine?
    1. cwjakesteel's Avatar
      cwjakesteel - 07-10-2012, 07:33 PM
      Quote Originally Posted by BMANN2 View Post
      @cwjakesteel

      I tried what you suggested and unfortunately it didn't work. How are people showing these full system specs, maybe that can help if i get mine?
      I don't know the significance of it. From what jax told me, it just tells you which IOS's are missing, in need of an update, your mIOS version, your Wii region and version.

      Nothing to do with DIOS MIOS. I mean, most of my IOS are all out-dated and it's working just fine!

      Also, what did you try that I suggested? Are you talking about Double Dash?

      Quote Originally Posted by 2Hack View Post
      Im on rev 58 and sa2 battle worked solely with neogamma...
      You mean that you tried it with other USB Loaders and it didn't work? But since DIOS MIOS works for you it must be a settings problem with the other USB Loaders.

      Hey Guys, remember how I couldn't get cheats to work? Well I was exploring We Hack Wii's IOS and RLV Download page and it told me that Gamecube Action replay is re-enabled for mios v4. I don't know if that says anything since mios is overwritten, but just a note, cause I still can't get ocarina to work.
    1. PhineasT's Avatar
      PhineasT - 07-11-2012, 03:49 AM
      Here's my syscheck.

      It looks odd... like all the iOSes I have are patched with the trucha bug except for a couple.

      Spoiler



      A follow-up.

      I bought a new (used) Wii, updated it to 4.3U then softmodded it. Worked perfectly.
      Installed DIOS MIOS 2.0. Can't run anything from USB.
      I'll be happy with running games from the SD so I'm switching back to DMLr59; must be my USB drive. It's a Western Digital 2TB USB 2.0 drive.
    1. Jax's Avatar
      Jax - 07-11-2012, 04:28 AM
      Quote Originally Posted by cwjakesteel View Post
      Does that also mean that if I install a new ios like IOS55, 56, and 57 I would need to reinstall the d2x for all of them?
      No, I would go through the Soft Mod Guide.

      That Guide will install and update everything.


      Quote Originally Posted by PhineasT
      Here's my syscheck.

      It looks odd... like all the iOSes I have are patched with the trucha bug except for a couple.

      Spoiler


      Yes they are patched, and they don't need to be.
      You didn't use the Guide from our site...Did you?
    1. chrisplushado's Avatar
      chrisplushado - 07-11-2012, 06:18 AM
      is it supposed to ask me to copy the game to SD?
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 06:24 AM
      Quote Originally Posted by chrisplushado
      is it supposed to ask me to copy the game to SD?
      No, try a different version of USB Loader GX. After clicking start it should go straight to the DIOS MIOS splash screen.
    1. ltrain23's Avatar
      ltrain23 - 07-11-2012, 08:55 AM
      Quote Originally Posted by chrisplushado View Post
      is it supposed to ask me to copy the game to SD?
      You need to update USB loader GX to the modded version. There is a link to it earlier in this thread.

      Sent from my MoPho using Tapatalk 2
    1. coreyrobbins's Avatar
      coreyrobbins - 07-11-2012, 09:05 AM
      Hi, I was wondering if someone could help me. I've followed all the steps in this guide to a tee, and whenever I try and load a gamecube game from my HD using cfg usb loader, it hangs at the dios mios screen. I've tried two games so far... ssb melee and wind waker. I softmodded my wii using the guide on this site, however I used it to override another softmod a friend had done for me. I think he used the pimpmywii 2.30 app to install ios's and cios's initially. I'm also having problems with certain wii games freezing (but I assume I would post that in another thread) and mw3 hangs on the first loading screen. Any help with these issues would be greatly appreciated! Thanks!
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 11:46 AM
      So happy, just used GCMM and a MadCatz card to backup all my saves from my GC games but now I'm a little stuck. How can I make the USB Loader GX find these saves when I play a game from USB?

      Nevermind, had a searched a little harder on the official release page for DIOS MIOS, I'd have seen gci2nmm save converter :P
      I'll post back the results of how well (or if) it works.
    1. PhineasT's Avatar
      PhineasT - 07-11-2012, 12:02 PM
      Quote Originally Posted by PhineasT View Post
      Here's my syscheck.

      It looks odd... like all the iOSes I have are patched with the trucha bug except for a couple.

      Spoiler

      Following up.

      I bought a new (used) Wii and followed the guide on this site to softmod it. The modding worked so I then installed DIOS MIOS 2.0. Same as before. Can't run anything off of USB. At this point I'm going to assume that it's the USB drive that is the problem as it's the only constant across three wiis. I think at this point I'll just stick to running them from the SD card. :-(
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 12:05 PM
      Quote Originally Posted by PhineasT

      Following up.

      I bought a new (used) Wii and followed the guide on this site to softmod it. The modding worked so I then installed DIOS MIOS 2.0. Same as before. Can't run anything off of USB. At this point I'm going to assume that it's the USB drive that is the problem as it's the only constant across three wiis. I think at this point I'll just stick to running them from the SD card. :-(
      Try a SanDisk Cruzer USB flashstick. I have a 8gb that works. It's not the best way to do it but if you don't have a lot of space on your SD then it's a good fix till an update makes DIOS MIOS more compatible with other HDDs.

      Also I don't if this has anything to do with it, but you don't appear to have d2x IOSs or Hermes cIOS.
    1. Jax's Avatar
      Jax - 07-11-2012, 12:31 PM
      Quote Originally Posted by SNES_Master View Post
      Try a SanDisk Cruzer USB flashstick. I have a 8gb that works. It's not the best way to do it but if you don't have a lot of space on your SD then it's a good fix till an update makes DIOS MIOS more compatible with other HDDs.

      Also I don't if this has anything to do with it, but you don't appear to have d2x IOSs or Hermes cIOS.
      Yes PhineasT does has cios and Hermes installed.

      PhineasT is just using an outdated system Check.
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 12:39 PM
      Ah ok, lol. I just didn't see where it said "hermes" as mine do or "d2x" so I didn't think he had them :P

      I'm still a noob this though. Is there a guide on how to use gci2nmm? I try to open it but it instantly closes itself.
    1. Jax's Avatar
      Jax - 07-11-2012, 12:45 PM
      We all learn something new every day,it's not a biggie.

      Also look here for the answer ,"For Dios Mios Being Dependent of Cios To Load GC Games".Dios MIos And Cios Relations
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 01:06 PM
      Quote Originally Posted by jax View Post
      We all learn something new every day,it's not a biggie.

      Also look here for the answer ,"For Dios Mios Being Dependent of Cios To Load GC Games".Dios MIos And Cios Relations
      Thank you, that explains it pretty good
    1. cwjakesteel's Avatar
      cwjakesteel - 07-11-2012, 01:19 PM
      Quote Originally Posted by ltrain23 View Post
      You need to update USB loader GX to the modded version. There is a link to it earlier in this thread.
      The link's in the guide on the first page.

      Quote Originally Posted by SNES_Master View Post
      Soon as I double click it to open it instantly closes. Do you have any info that can help me get this working or possibly a different program that would work?
      Try dagging the necessary files to it, or adding the correct command to the end of a shortcut you create to the .exe file. Read the Readme file to find out the right commands. If the command is "a" then add " -a" to the end of the target in the properties of the shortcut you make to the original .exe.

      Quote Originally Posted by coreyrobbins View Post
      Hi, I was wondering if someone could help me. I've followed all the steps in this guide to a tee, and whenever I try and load a gamecube game from my HD using cfg usb loader, it hangs at the dios mios screen. I've tried two games so far... ssb melee and wind waker. I softmodded my wii using the guide on this site, however I used it to override another softmod a friend had done for me. I think he used the pimpmywii 2.30 app to install ios's and cios's initially. I'm also having problems with certain wii games freezing (but I assume I would post that in another thread) and mw3 hangs on the first loading screen. Any help with these issues would be greatly appreciated! Thanks!
      Try using USB Loader GX instead. Also, if some wii games are freezing, you probably are using the old cIOS. Download and install the newest d2x cIOS's. You are probably also using the wrong cIOS.

      I know games like COD Black Ops needs ios 57, so you need to use a cIOS of base 57. Otherwise it will freeze. It's probably the same problem with MW3. You can see which base IOS you need in CFG Loader's info panel for each individual game.
    1. SNES_Master's Avatar
      SNES_Master - 07-11-2012, 01:40 PM
      Quote Originally Posted by cwjakesteel

      Try dagging the necessary files to it, or adding the correct command to the end of a shortcut you create to the .exe file. Read the Readme file to find out the right commands. If the command is "a" then add " -a" to the end of the target in the properties of the shortcut you make to the original .exe.
      Thank you, it worked so happy to be able to resume my Simpsons Hit & Run save
    Page 11 of 114 FirstFirst ... 9101112132161111 ... LastLast