Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: How to remove the wii nand from the motherboard????

  1. #11
    New Member
    Join Date
    Apr 2011
    Posts
    80
    Thanks
    9
    Thanked 1 Time in 1 Post
    I have bought a hot air rework station

  2. #12
    Retired WiiHacks Staff Krafter's Avatar
    Join Date
    Dec 2009
    Posts
    4,426
    Thanks
    460
    Thanked 1,093 Times in 857 Posts
    Blog Entries
    5
    If you have a rework station then set it on about 400 and place a exacto knife or similar under the edge of the chip and GENTLY pry on one side at a time as you heat it. Make sure you are heating both sides of the chip at the same time. It will pop off once it is hot enough. If you pry too hard you will break it and your out of luck.

    Did I say Gently pry? If not then I intended to.
    Last edited by Krafter; 04-17-2011 at 08:54 PM.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •